Recall Information

Description

Vehicle description: super duty trucks and chassis-cabs equipped with 5.4L manual transmission powertrains. The accelerator cable core wire can wear the cable conduit end fitting due to a fifteen degree angle it makes with the conduit at the throttle body end. This could also lead to wear or separation of strands of the core wire, which could prevent the throttle from returning to the idle position.

Safety Risk

A "stuck" throttle could adversely affect vehicle control.

Remedy

Dealers will replace the accelerator cable and throttle body.

Next Steps

Description

Vehicle description: pickup trucks equipped with gasoline engines and 8 foot boxes, may not fully satisfy the requirements of fmvss no. 301, "fuel system integrity." in a 30 mph frontal barrier crash test, a fuel tank vapor recovery valve separated internally. During the subsequent static rollover test, fuel spillage exceeded the specified rate.

Safety Risk

Fuel leakage, in the presence of an ignition source, could result in a fire.

Remedy

Dealers will install a stop plate assembly on the vehicle frame to prevent recovery valve contact with a frame crossmember during the impact sequence.

Next Steps

Description

On certain sport utility vehicles and pickup trucks, the speed control deactivation switch may overheat, smoke, or burn.

Safety Risk

This condition could lead to a fire. Fires have occurred while the vehicles were parked with the ignition 'off.'

Remedy

Ford Motor Company has authorized your dealer to perform the repairs under this program free of charge parts and labor. If you had the interim repair speed control system disconnect performed, the final repair will restore operation of the speed control system.

Next Steps

Description

On certain heavy duty trucks equipped with 7.3L diesel engines, the camshaft position sensor located on the engine of the vehicle may function intermittently, possibly resulting in an engine stall.

Safety Risk

In the event of an engine stall, a crash could result without warning.

Remedy

Dealers will inspect the sensor and replace it with an improved camshaft position sensor free of charge. The recall began on December 29, 2007. Owners may contact Ford at 1-866-436-7332.

Next Steps

Description

Vehicle description: passenger cars, sport utility vehicles, and light and medium duty pickup trucks. A switch located in the plastic cover of the wiper Motor gear case could malfunction and overheat, potentially resulting in loss of intermittent wiper function, loss of wiper park function, complete loss of wiper function, or ignition of the plastic cover material. Switch malfunction is most likely to occur when the intermittent setting of the wipers is being used, or when snow or ice obstructs the blades from returning to the "parked" position at the bottom of the windshield. These vehicles were built at the following assembly plants: atlanta plant from 2/11/00 through 7/31/00; chicago plant from 2/14/00 through 8/4/00; kansas city plant from 2/26/00 to 9/4/00; kentucky truck plant from 2/18/00 to 8/31/00; michigan truck plant from 2/23/00 through 8/3/00; norfolk plant from 2/21/00 through 7/27/00; wayne stamping and assembly plant from 2/25/00 through 8/15/00; and wixom plant from 2/15/00 through 8/8/00.

Safety Risk

Loss of visibility while driving increases the risk of a crash.

Remedy

Dealers will inspect the date code on the wiper Motor. Motors built with the suspect time frame will have the wiper Motor gear case cover replaced. Owner notification began August 20, 2001. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact Ford at 1-866-436-7332.

Next Steps

Description

Ford is recalling model years 1995-2003 windstar, 2000-2003 excursion diesel, 1993-1997 and 1999-2003 F-250 sd through F-550 sd diesel, 1992-2003 E-150 through E-550, 1995-2002 explorer, 1997 and 2002 mercury mountaineer, 1995-1997 and 2001-2003 ranger, and 1994 F53 vehicles equipped with the texas instruments speed control deactivation switch (scds). The scds may leak internally and then overheat, smoke, or burn.

Safety Risk

A vehicle fire could occur with or without the engine running.

Remedy

Ford will notify owners that dealers will install a fused wiring harness in line with the scds. On 1999-2003 windstar vehicles with a leaking scds, dealers will also inspect the ABS control module connector and repair as necessary. Repairs will be completed free of charge. The safety recall began on October 27, 2009. Owners may contact Ford at 1-888-222-2751.

Next Steps